Gab with Gaby

An engineer's creative corner studio.

Yellow

Ribbon Roses

Diy, CraftsGabriela SimsComment

These are a few roses that I made from organdy ribbon.  

image.jpg

These are simple to create, here's what you'll need: 

  • Ribbon that you like (1-1/2 inches wide and 30 inches long)
  • Stem wire 
  • Needle and thread coordinating colors will be best, but any should work. 
  • Wire cutters  
  • Scissors
  • Green satin fabric (1/2 inch wide by 6 inches long) 
  • Fabric glue

 

 

Start by folding ribbon down at a 45 degree angle about 3" from one end. 

image.jpg

Then fold down the again forming a point. 

image.jpg

Continue using the long part as the "working" ribbon.

image.jpg

You'll form a "diamond".​

image.jpg

Continue like this until you have 4 layers of diamonds.​

image.jpg

Now you'll find a tiny hole in the center: 

image.jpg

Thread the end of the ribbon you were folding ("working" ribbon end) through the hole, gently, until there is enough to  grab, try not to pull too hard.  

image.jpg
image.jpg

Twist the end in a clockwise direction while gently holding the layers in the opposite hand and releasing them as the edges begin to twist. ​

image.jpg

When you reach the end grab the loose end and bunch it with the end you pulled through and sew them together with your needle and thread. 

image.jpg
image.jpg

Trim excess ribbon.​

image.jpg

Cut length of wire to about 5". 

image.jpg

Wrap wire around edge of fabric. 

image.jpg

Cover stitches with small piece of green fabric and glue, then you're done. 

image.jpg

Now you've made your first flower, make a bunch and turn them into pins or into a tiny garden! 😃 

image.jpg
image.jpg

http://